Documented workshop project
1986 Toyota Hilux 3UZ-FE V8 Swap | R150F Standalone Harness Build
Jason’s 1986 Toyota Hilux YN67 4WD is being prepared for a 3UZ-FE V8 from a 2005 Toyota Crown UZS186 with a Toyota R150F manual transmission. This workshop video documents the standalone wiring harness build, ECU integration and live test verification.
Inside this build
- Recipient vehicle
- 1986 Toyota Hilux YN67 4WD, right-hand drive
- Donor engine
- 2005 Toyota Crown UZS186 3UZ-FE
- Drivetrain
- R150F manual gearbox and VF1A transfer case
Built around the Hilux installation
The harness layout is prepared for an ECU behind the glovebox or stereo. It passes through the passenger-side firewall before routing across the vehicle. This matters when agreeing branch lengths and the position of the ECU, accelerator pedal, diagnostic socket and power distribution.
Engine management and vehicle connections
The documented package includes the electronic throttle pedal, airflow meter, engine grounds, oxygen sensors, starter and transmission interfaces. The vehicle connections provide for cruise control, A/C control, OBD-II diagnostics and the vehicle-speed signal. A dedicated fuse-and-relay system is part of this build.
ECU preparation and workshop verification
The original workshop description records manual-transmission ECU configuration, immobilizer configuration and throttle-response work. The package is checked with OBD-II diagnostics and an engine-run test before delivery. That verifies the supplied system on the stand; it does not replace commissioning in the completed Hilux.
This is workshop verification of the supplied system. Donor ECU details, chassis integration and final installation conditions vary by project. These modified engines are used in off-road, track, competition, marine and other custom applications.
Find the service for your engine and gearbox
Review the relevant setup, then send your ECU and build details for compatibility and a complete quote.


