LEXUS V8 Engines LLC

Documented workshop project

1994 Land Cruiser 2UZ V8 Swap | 4WD Harness Rebuild + Test Run

A rebuilt 2UZ V8 wiring package is prepared for a 1994 Toyota Land Cruiser four-wheel-drive swap. The workshop video follows the harness walkthrough and test run for the supplied system.

Project dateOctober 25, 2026
Video lengthNot listed
Published on YouTubeOctober 25, 2026

Inside this build

Recipient vehicle
1994 Toyota Land Cruiser
Donor engine
Toyota 2UZ-FE V8
Drivetrain
Automatic transmission and four-wheel-drive integration

Adding 4WD interfaces to a supplied 2WD harness

The project starts with a two-wheel-drive engine harness and adds the four-wheel-drive and transfer-case wiring required for this Land Cruiser package. The walkthrough identifies transmission sensors, the neutral-safety switch, selector connections and the separate ECU and instrument-cluster speed signals.

Connector renewal and serviceable routing

The rebuild includes replacement injector connectors and renewed coil-connector terminals and seals. The recorded layout covers reinforced loom routing, sensor connections, an extended airflow-meter branch, alternator wiring, battery power and the fuse-and-relay centre. ECU connectors, the labelled vehicle interface and accelerator/OBD-II patch harness are identified before testing.

What the diagnostic sequence actually shows

The video shows a live engine test and OBD-II check. A stored coil-related code is discussed and cleared during the recorded sequence; the final scanner screen reports no fault codes. This is a bench check of the supplied wiring package before installation in the customer’s vehicle, rather than a claim that no code appeared at any stage.

This is workshop verification of the supplied system. Donor ECU details, chassis integration and final installation conditions vary by project. These modified engines are used in off-road, track, competition, marine and other custom applications.

Find the service for your engine and gearbox

Review the relevant setup, then send your ECU and build details for compatibility and a complete quote.