LEXUS V8 Engines LLC

Documented workshop project

2003 2UZ-FE V8 Swap Wiring for a 1989 Toyota 4Runner | R150 Manual

A 2003 2UZ-FE donor system is prepared for a 1989 Toyota 4Runner with an R150 manual gearbox. This workshop video documents the swap-wiring package and its engine-management connections.

Project dateOctober 25, 2026
Video lengthNot listed
Published on YouTubeOctober 25, 2026

Inside this build

Recipient vehicle
1989 Toyota 4Runner
Donor engine
2003 Toyota 2UZ-FE V8
Drivetrain
R150 manual gearbox and manual transfer case

Rebuilding the original engine harness

This package uses a rebuilt 2UZ-FE harness with renewed terminals, seals and connectors. The walkthrough shows the crank and oil-pressure branches, starter and knock-sensor connections, engine grounds, coils, injectors and harness supports.

Keeping the vehicle interfaces together

The supplied interfaces include the accelerator pedal, OBD-II socket, cruise control and vehicle speed. The vehicle plug also provides tachometer, temperature-gauge, oil-pressure and charging-light connections. The package includes A/C compressor-clutch control and a documented fuse, relay and fuel-pump control arrangement.

Manual configuration and the recorded test

The ECU is configured for the automatic-to-manual conversion, with the immobilizer configuration and throttle-response work described in the original project record. The video then shows a successful bench start followed by a diagnostic scan reporting no fault codes at that check. Final vehicle installation and road commissioning remain separate.

This is workshop verification of the supplied system. Donor ECU details, chassis integration and final installation conditions vary by project. These modified engines are used in off-road, track, competition, marine and other custom applications.

Find the service for your engine and gearbox

Review the relevant setup, then send your ECU and build details for compatibility and a complete quote.